Your Town, U.S.A

American Alarm Co.

Dependability and Service
Burglar and Fire Alarms


Currently:
April 21, 2014
12:32 AM
DSC Power Series 632/832/864  
Print this page Print this page Email this page Email this page


Click here for DSC Power Series 832 User's Manual

Programming Security Codes

Programming codes from an LED Keypad:

The Master Code
To program the Master Code, enter [*][5][current Master Code][40][new Master Code].The Master Code must be four digits unless otherwise indicated by your installer. Enter digits 0 through 9 only.
Press [#] to return to the Ready state.

 

Be sure to record your new Master Code on the "System Information" page in this booklet. NOTE: We recommend that the factory default Master Code [1234] not be used.

Additional Codes
Up to 36 additional codes may be programmed. Codes 01-32 are regular access codes. Codes 33 and 34 are duress codes. Codes 41 and 42 are the partition 1 and partition 2 master codes, respectively.

 

To program a new code:
Enter [*][5][Master code][code number][new access code]. The code number is a double-digit number from 01-34 or 41-42.

Access codes must be four digits long. Enter digits 0 through 9 only.

To exit code programming, press [#].

If an access code already exists for the code number you have selected, it will be replaced by the new code. Be sure to record your new code(s) on the "System Information" page in this book.

To erase a code:

Enter [*][5][Master Code][code number][*]. To exit code programming, press [#]. The master code cannot be erased.




Copyright © 2000-2009 A & A American Alarm Co.

Powered by Cit-e-Net